Normas ISO Publicadas

Steel structures — Structural bolting — Test method for determining the slip factor for faying surfaces of slip-resistant connections

Genomics informatics — Challenges and standardization needs for secondary use of clinical genomics data

Specification and qualification of welding procedures for production welding of steel and nickel-base castings

Plastics film and sheeting — Determination of gas-transmission rate — Part 2: Equal-pressure method

Transportable liquid oxygen systems for medical use — Part 2: Particular requirements for portable units

Operating procedures of chicken slaughtering

Sludge recovery, recycling, treatment and disposal — Laboratory chemical conditioning procedure

Water reuse in urban areas — Guidelines for centralized water reuse system — Part 1: Design principle of a centralized water reuse system

Water reuse in urban areas — Guidelines for centralized water reuse system — Part 2: Management of a centralized water reuse system

Motorcycles — Measurement method for evaporative emissions — Part 3: VT-SHED test procedure

Tobacco heating systems — Vocabulary — Amendment 1

Lithium — Vocabulary

Information technology — Radio frequency identification device conformance test methods — Part 6: Test methods for air interface communications at 860 MHz to 930 MHz

Systems and software engineering — Life cycle profiles for very small entities (VSEs) — Part 5-2-1: Organizational management guidelines

Specification and demonstration of system reliability of single-use drug delivery systems

Fibre-reinforced polymer (FRP) reinforcement of concrete — Test methods — Part 2: FRP sheets

Intelligent transport systems — Definition of data elements and data frames between roadside modules and signal controllers for cooperative signal control

Natural gas upstream area — Determination and calculation of shale brittleness index — Part 2: Determination of shale mechanical characteristics based on triaxial testing method

Fine ceramics (advanced ceramics, advanced technical ceramics) — Methods of test for reinforcements — Determination of tensile properties of filaments at ambient temperature

Coal — Froth flotation testing — Part 3: Release evaluation