Normas ISO Publicadas

Refrigerated light hydrocarbon fluids — Sampling of liquefied natural gas — Continuous and intermittent methods

Electronic fee collection — Information exchange between service provision and toll charging

Composites and reinforcement fibres — Carbon fibre reinforced plastics (CFRPs) and metal assemblies — Combined stress test

Solid recovered fuels — Methods for the determination of the content of elements (Al, Ca, Fe, K, Mg, Na, P, S, Si, Ti, As, Ba, Be, Cd, Co, Cr, Cu, Hg, Mo, Mn, Ni, Pb, Sb, Se, Sn, Tl, V, Zn)

Information technology — Process assessment — Process assessment model for system life cycle processes

Fine ceramics (advanced ceramics, advanced technical ceramics) — Relative method for determining thermal conductivity of ceramic coatings

Space systems — Product assurance requirements for commercial satellites

Nicotine pouches — Test method for pH

Electronic fee collection — Interface definition for on-board account using an integrated circuit card (ICC)

Visualization elements of PLM-MES interface — Part 2: 3D error feedback in heavy industry

Information technology — Telecommunications and information exchange between systems — Local and metropolitan area networks — Part 1AS: Timing and synchronization for time-sensitive applications in bridged local area networks — Amendment 1: Inclusive terminology

Rapeseed — Determination of chlorophyll content — Spectrometric method — Amendment 1: Preparation of the calibration curve to determine the k factor

Plastics — Disintegration field test of plastics under water environmental conditions

Performance rating of centrifugal refrigerant compressor

Aerospace — Tubing outside diameters and thicknesses — Metric dimensions

Graphical symbols — Safety colours and safety signs — Registered safety signs — Amendment 9

Capability of detection — Part 7: Methodology based on stochastic properties of instrumental noise

Intelligent transport systems — Local dynamic map

Polyphenylsulfone (PPSU) — Effect of time and temperature on expected strength

Furniture — Tests for surface finishes — Part 1: Assessment of resistance to cold liquids