Normas ISO Publicadas

Fire detection and alarm systems-- Part 15: Point-type fire detectors using smoke and heat sensors

Information technology -- Office equipment -- Method for measuring digital printing productivity

Wheelchairs-- Part 2: Typical values and recommended limits of dimensions, mass and manoeuvring space as determined in ISO 7176-5

Board -- Determination of bursting strength

Vanilla -- Vocabulary

Plastics hoses and hose assemblies for suction and low-pressure discharge of petroleum liquids -- Specification

Soft soldering fluxes -- Test methods-- Part 5: Copper mirror test

Calculation of the impact of daylight utilization on the net and final energy demand for lighting

Textiles -- Determination of antifungal activity of textile products-- Part 2: Plate count method

Nuclear fuel technology -- Chemical separation and purification of uranium and plutonium in nitric acid solutions for isotopic and isotopic dilution analysis by solvent extraction chromatography-- Part 1: Samples containing plutonium in the microgram range and uranium in the milligram range

Nuclear fuel technology -- Chemical separation and purification of uranium and plutonium in nitric acid solutions for isotopic and isotopic dilution analysis by solvent extraction chromatography-- Part 2: Samples containing plutonium and uranium in the nanogram range and below

Machine-made textile floor coverings -- Determination of dimensional changes after exposure to heat and/or water

Plastics -- Standard table for reference global solar spectral irradiance at sea level -- Horizontal, relative air mass 1

Non-destructive testing -- Ultrasonic testing -- Reference blocks and test procedures for the characterization of contact probe sound beams

Road vehicles -- Blended fuels refuelling connector

Fine ceramics (advanced ceramics, advanced technical ceramics) -- Thermophysical properties of ceramic composites -- Determination of thermal expansion

Industrial trucks -- Verification of stability-- Part 3: Reach and straddle trucks

Plain bearings -- Thin-walled half bearings with or without flange-- Part 1: Tolerances, design features and methods of test

Continuous hot-dip zinc-coated and zinc-iron alloy-coated carbon steel sheet of structural quality

Identification cards -- Integrated circuit card programming interfaces-- Part 1: Architecture